Epoxy Floor Adhesion Test

By use of a portable pull off adhesion tester a load is increasingly applied to the surface until the dolly is pulled off.

Epoxy floor adhesion test.

Cleaning your epoxy floor. In many instances it is necessary and is always advisable to field test the suitability of the substrate for adhesion prior to the actual installation. Different adhesion rating systems were devised and evaluated. Test results were discussed and analyzed.

1 1 this test method covers procedures for evaluating the pull off adhesion strength of a coating on concrete. Implementation a test procedure to evaluate the adhesive strength of the epoxy coating was developed and is recommended for quality control. The test determines the greatest perpendicular force in tension that a surface area can bear before a plug of material is detached. The coating stuck extremely well causing the concrete to fail.

Epoxy could not be separated from concrete. The industry standard epoxy flooring test method is called the taber c 17 abrasion test. What the taber c 17 test does is to take a coating and apply an abrasion wheel with a certain weight on it and spin it at a certain rpm for a certain amount of time. Read to find out more about prepping concrete for a urethane coating.

Our epoxy wicks into the concrete and is much better than our competitors. Operators and different adhesion test procedures. The instructions for this type of adhesive state that the two components resin and hardener should be mixed in equal parts usually equal lengths of both parts. A more quantitative test for adhesion is the pull off test where a loading fixture commonly called a dolly or stub is affixed by an adhesive to a coating.

The force required to pull the dolly off or the force the dolly. Big box epoxy did not break. 106 adhesion testing kit vbp 4195 direct to concrete epoxy kit competitor a epoxy kit competitor b epoxy kit competitor c epoxy kit competitor big box epoxy kit concrete mixing materials and application materials. Anything under 300 psi means it can be separated from your concrete floor.

Elcometer adhesion puller was attached to the adhesion pulleys and the test was run. The adhesion pully test demonstrated that this coating pulled the most concrete from the floor. All other test methods are just marketing gobble d gook. During adhesion testing with elcometer pull tester top layer of concrete slab pulled off with no delamination of our epoxies.

Typically a two pack epoxy adhesive is supplied with adhesion test units. Typical epoxy adhesion ratings are 250 psi or less. Adhesion pulley test a total of five different epoxy primer sealers were tested in the adhesion pulley test.